Maytag Washer Won’t Spin
If your Maytag washer is not spinning, or your Maytag washing machine clothes are wet after the cycle the problem may lie with the lid switch assembly or faulty motor.
This switch is responsible for keeping the washer halted whenever the lid is open. If the assembly has malfunctioned, the washer will not spin.
Another problem can be the motor coupling, which connects the motor with the device’s transmission. The motor coupling can fail if the water is overloaded or generally suffers from wear and tear over time.
Possible Solution(s):
- Check the motor by putting your hand inside and feeling around, you can check the motor.
- The motor is definitely damaged if it seems flimsy or unsteady.
- In that situation, you ought to get in touch with a seasoned appliance repairman.
- Check the lid switch assembly with a multimetre for continuity. If there isn’t any, replace the assembly.
- By removing the bottom panel, you can examine the drain pump and look for any obstructions there.
Maytag Washer Is Making Excessive Noise
If your Maytag washer is generating an excessive amount of noise, there may be an issue with the bearings or with any loose items that are moving inside the washer. The washing machine has two bearings, one inside the back drum and the other in the centre of the outer tub.
Possible Solution(s):
- Look inside the washing machine for any buttons or coins that might be jiggling about.
- Place the washing machine on a level platform and balance it using a spirit level.
- Complete machine disassembly is required to replace the bearing, and it is best carried out by a qualified individual.
Maytag Washer Won’t Agitate
If your Maytag washing machine isn't agitating, the agitator repair kit is usually the source of the issue. A drive belt that has become loose or worn from use and abrasion may also be the cause.
Possible Solution(s):
- Replace the agitator repair kit.
- Replace the drive belt.
Maytag Washer Stops Abruptly
Your Maytag washing machine's door switch or water input could be broken if it unexpectedly stops mid-cycle. When the door is closed, the controller sends the signal to the machine to begin, but if it malfunctions, the washing machine will halt mid-cycle.
A defective water inlet valve that has lost its continuity may also be the cause.
Possible Solution(s):
- Make sure the power supply is correctly connected into the socket and that the circuit is not tripped if the Maytag washer loses power mid-cycle.
- Check the power source and confirm that the washer is properly inserted into the socket as potential solutions. Make that the circuit has not been tripped and that the power cord is not defective.
- The door switch needs to be replaced, so call a specialist.
- To replace the water inlet valve, a technician is needed.
